Jessem "Paralign" question

Viewed the Jessem videos for both 08300 ( Paralign ) and the smaller 08350

08350 demonstrates the method for making a T joint with vertically oriented holes.
08300 video does not, is it possible with this model ?

Picture attaching a 1 x 2 cross stringer/stretcher to the mid point inner face of a 1 x 4 table apron.

I would prefer the built in clamping of the Paralign model but not at the expense of not being able to perform this operation.

Thank you for your replies.

This entry passed through the Full-Text RSS service - if this is your content and you're reading it on someone else's site, please read the FAQ at http://ift.tt/jcXqJW.

Jessem "Paralign" question