Engraving Greyscale on Trotec Speedy 100

Hi Guys and Girls

Firstly excuse my ignorance.

I have recently purchased a Trotec Speedy 100 and I am little bit confused as to the greyscale settings.

I engrave a lot of Trophy plates on laser ply and often have to pick up different tonal range in logos. I have previously used a universal laser where I can send the logo down to the laser without converting it into a bitmap hence picking up the tones.

I have noticed with the trotec that job control automatically converts to bitmap limiting the detail that i can engrave with.

I have been using the standard - stucki - setting.

My question is.. am i doing something wrong.. should i be using different settings ???

Thanks in advance

Pat

(.-.)

Engraving Greyscale on Trotec Speedy 100