Hello everybody once again I've had a few people ask me to show how I am able to turn the projects
I've been posting. This is a simple Walnut bowl except that one of the pieces has a large knot almost to the edge
where I'll be cutting.
I had to lay this up just right so when cut / turned all voids were gone; I start w/ 2 - 9" x 9" plus blanks and miter off the extra after drawing an X and the circle. (I"ll show how I do this)
I'll try to explain w/ each posting of photos; if I had a video camera I would post a video my camera shoots very short videos only.
I hope this helps you guys & gals that are new to turning I'm have a blast doing these projects and have a great number of ideas yet to try, so I hope you stick around and ask questions.
Bruce
The first set will show prepping the blank to mount on the lathe after coming out of the glue press after 24 hrs.
I've been posting. This is a simple Walnut bowl except that one of the pieces has a large knot almost to the edge
where I'll be cutting.
I had to lay this up just right so when cut / turned all voids were gone; I start w/ 2 - 9" x 9" plus blanks and miter off the extra after drawing an X and the circle. (I"ll show how I do this)
I'll try to explain w/ each posting of photos; if I had a video camera I would post a video my camera shoots very short videos only.
I hope this helps you guys & gals that are new to turning I'm have a blast doing these projects and have a great number of ideas yet to try, so I hope you stick around and ask questions.
Bruce
The first set will show prepping the blank to mount on the lathe after coming out of the glue press after 24 hrs.
9" x 4" Walnut Bowl Step by Step
Aucun commentaire:
Enregistrer un commentaire