I need help to finish this up. I have a frame built with a 1/4" groove. I have 2 panels from 4/4 cherry. I am using my 4 1/2 to raise the panels. I used my gauge to mark the edge thickness to 1/4". I planed a chamfer down to that line, and then I finished raising the panel down to my marks on the face...
My question now is, how do I fit it in the groove? I think I missed a step.
The toolbox build I am trying to a copy from the Paul sellers subscription website. I am trying to copy it just from the pictures, but I can't figure this part out.
The groove in the frame is 3/4" deep, so how do I create that "Step" in the frame? such that I can slide it in?
Hopefully these pictures help explain my problem.
Frame:
Groove:
Panels:
Raised Panel:
My question now is, how do I fit it in the groove? I think I missed a step.
The toolbox build I am trying to a copy from the Paul sellers subscription website. I am trying to copy it just from the pictures, but I can't figure this part out.
The groove in the frame is 3/4" deep, so how do I create that "Step" in the frame? such that I can slide it in?
Hopefully these pictures help explain my problem.
Frame:
Groove:
Panels:
Raised Panel:
How to fit a raised panel?
Aucun commentaire:
Enregistrer un commentaire