Howdy all, I'm trying to recreate an edge profile for a timberframe-ish project I'm working on. The profile is basically a large round over, maybe 1" radius, with fillets on the top and bottom. The picture with the lovely green and purple paint shows the original cut.
I've purchased a 5/8" round over bit that seemed like it could do the job if I took two passes on the same edge, the two passes being perpendicular to each other. I took off the bearing and ground off the little housing for the screw so that the two passes could line up. My problem is that I can't seem to get a continuous curve by doing this, and I feel like I'm just missing something obvious. The second picture shows one of my attempts. Any advice?
IMG_2829.jpgIMG_2917.jpg
This entry passed through the Full-Text RSS service - if this is your content and you're reading it on someone else's site, please read the FAQ at http://ift.tt/jcXqJW.
Double pass with round over bits
Aucun commentaire:
Enregistrer un commentaire